Xhorse Condor XC-MINI Plus II Technical Service

---

Matched product:

Xhorse Condor XC-MINI Plus II Technical Service

Xhorse Condor XC-MINI Plus
1.Condor XC-MINI Plus Install Cutter
1)Put the cutter into the mounting hole and make sure the cutter goes to the limit of the top.
2)Use the cutter tightening wrench to clockwise fix the cutter
condorii

1.Condor XC-MINI Plus Install Clamp
1)Loosen the clamp-tightening wrench by turning it counter-clockwise.
2)Select the correct clamp and slide in the clamp to the clamp holder and push it to the limit of left.
3)After the clamp is put in the clamp platform, turn the clamp tightening wrench clockwise.
condor ii
2. Activation
1)Select the machine language
2)After the machine is connected to the power cord, turn it on, enter the main interface, and click the “START TO SET” button
condor ii
3)Click to select a Wi-Fi network
condor ii
4)After entering the password, click the “Connect” button, and click “NEXT” below after success. (Login the XHORSE account)
condor ii
5)Users can choose account login or quick login (new users need to choose quick login and register)
condor ii
condor ii
6)After logging in successfully, click “Send” to bind the device.
condor ii
7)The device is successfully activated, click “START TO USE”.
condor ii

3. Condor XC-MINI Plus Calibration
This CONDOR II Machine adopts Android system, no need for “Height Calibration” and “Clamp Calibration”, just move the probe and the cutter to the top.
1)Enter the operation main interface and click on “Settings”.
condor ii
2)Click on “Cutting Calibration”.
condor ii
3)Operate by following the tips and click on “Continue”.
condor ii
4)Clean the cutter and probe and working area with a brush. Click on “Continue calibration” and  now the calibration is finished.
condor ii

4. Condor XC-MINI Plus Update
Connect the machine to the Internet, click “Update” in the upper right corner of the main page.
condor ii
Click the “UPDATE” button on the right to upgrade.