Xhorse VVDI2 V4.3.0 add BMW FEM/BDC function

Original Xhorse VVDI2 Commander Key Programmer for VW/Audi/BMW/Porsche/PSA Full Version


VVDI2 now add VB-03 BMW FEM/BDC functions,you can pay for this function.

VVDI2 - BMW FEM/BDC system(function released and available, just no user manual)

Users can refer to following information (3 steps for make keys:get key info->programming FEM/BDC system->make keys)

 

1.support make new key with ignition switch(support add spare key and all key lost, all key lost require ISN)

2.support reset FEM/BDC KM(cluster require reset manually)

3.support erase key(after erase the key position become blank position)

4.support backup coding

5.support restore coding

Notes:

1.backup coding and restore coding can direct operation generally.

2.add keys, reset KM, erase key must programming FEM/BDC system first

3.in FEM/BDC interface, if 'get key info' the type not support, it will show:customer should use "BMW E-sys software" program FEM/BDC system.
then programming FEM/BDC system with VVDI2-BMW

4.when operation on 'programming FEM/BDC system'interface,please don't close this software window until all procedures completed.

5.programming FEM/BDC system, require soldering and get eeprom.（FEM 95128 chip, BDC 95256 chip）usually there are 2 same chips on the module,
please refer to the software diagram, select the correct one.

6.programming FEM/BDC system,must restore the original eeprom, restore coding.if cannot restore coding or after restore coding assemble FEM/BDC module back to car,
but with problem(such as the remote control cannot start the car 

or the car with window problem)please use "BMW E-sys software" coding for FEM/BDC system

7.if connect power to FEM/BDC module, but the relay keep ringing,please contact technical support for help.usually operation on FEM/BDC should be ok,just need to programming.