1. I did a few tests today and this is what I found out.
It seems that VVDI prog reading speed is dependent on the processor speed of the computer.
i7 @ 4.4ghz Windows 7 64 bit = 2mins 30 seconds.
Other programmers do not seem to be affected by processor speed at all.
I also would of thought this was a fairly easy question to answer without me doing all the testing
2.Today read Rover CEM success with Last version
It Was HSE 2008 onde motor supercharged.
3. Q: Has anyone had any problems reading CAS 3 with 0L01Y mask. Is it safe to read with VVDI prog.
A: I read it many times ...it’s safe
4. Q: Can vvdi prog erase the first two lines in M35080 M35160 (80D0WQ, 160D0wQ) ?
A: Tested today M35080v and 080d0wq. It erases perfect. Also the first two lines
5. ST 10F269
megan steering power unite
6.Question: I need your advise regarding reading Mask 1M12S secured via Vvdi Prog, if someone read successfully yet or not
Mask 1m12S normally found inside LandRover RangeRover Sport 2016 up KVM RFA module.
Answer: BCM module?
In the 8-OTHER,there is LANDROVER and choose the RFA-V2(secured) to read
RFA should be ok.
Yes i did Successfully
EZS VW Crafter
old version MC9S12DT256 (0L01Y) - read/write eeprom and flash OK
new version MC9S12XDT384 (1L15Y) - read/write eeprom and flash OK
cas4 1l15y R/W eeprom and flash okay
frm3 d flash r/w okay
E-series CA key write okay
W639 545 02 08 (0L02M)
W639 545 21 08 (0L01Y)
V3 CABLE all good.
W203 545 01 08 (4J74Y) OK
W203 545 05 08 (1J35D) OK
MCU V3 CABLE
W169 545 17 08 5L40K OK
W906 545 40 08 SPRINTER (0L01Y)
MC9S12 V1 CABLE
M35080,080dqw and 160dqw try to reset not ok, unsuccesful.